Turbo 36 patio doors

The place for Fairline discussions!
Post Reply
chris c
Posts: 1
Joined: Thu Jul 14, 2011 8:59 am

Turbo 36 patio doors

Post by chris c » Thu Jul 14, 2011 11:04 am

Hello everyone, I am a new member to the Forum and only purchased my 1989 Fairline Turbo 36 last September, hence - new to everything! At the moment I have a problem with the sliding doors into the boat, It is very stiff and rough to slide. I have tried polish on the bottom runner, but to no avail. Is it possible to ajust the door ? I would be grateful for any help and advice.

Bosun
Posts: 67
Joined: Thu May 11, 2006 10:44 pm
Location: Fairline turbo 36

Post by Bosun » Thu Jul 14, 2011 1:11 pm

Hello Chris and welcome.
I had the same problem on mine 3 years ago. On mine there is a hole at the bottom of the door on both opening edge. You should be able to insert a screwdriver and adjust the rollers up or down. However mine were siezed up. I asked a local patio door repair guy to look at it. He stripped the door out and fitted new rollers for around ?100 . Works like new now.
Good luck

David Norman
Posts: 39
Joined: Tue Aug 26, 2003 7:38 pm
Location: Fairline 36 Sedan

Post by David Norman » Fri Jul 15, 2011 8:34 pm

Nearly Certain the Doors were manufactured by Trend marine, give them a call, very helpful.

Post Reply